Plate Bending - Capacities

The range of sections, plate thickness and configuration that we cold form in various materials is indicated below. However, we must stress that it is only an indication of our capability. If the section you need is not shown please contact us anyway - your design problem is our challenge.

CAPACITY CHART		ALL SIZES UP TO
FLAT BANDS		350 X 50
FLAT BANDS ON EDGE		175 X 40
ANGLES TOE OUT		160 X 160 X 20
ANGLES TOE IN		150 X 150 X 20
ANGLES AS VEE PULLEYS		160 X 160 X 20
ANGLES AS INVERTED VEE		160 X 160 X 20
TEES ON EDGE		160 X 160 X 20
TEES STALK OUT		160 X 160 X 20
TEES STALK IN		150 X 150 X 20
CHANNELS TOE OUT		432 X 102
CHANNELS TOE IN		432 X 102
CHANNELS X-X AXIS		203 X 76
BEAMS & JOIST AS RUNWAYS		406 X 178
BEAMS & JOIST X-X AXIS		203 X 102
COLUMNS AS RUNWAYS		240 X 240
SQUARES		110 X 110
ROUNDS		125 Diameter
TUBES		168.3 O/D x 10
S.H.S		250 x 150 x 10
R.H.S		200 X 100 X 8
NOT STANDARD		please send drawing
SPIRAL STRINGERS		advise plan radius & height
TEES		Split & straightened from beam & columns
PLATE ROLLING		up to 3050 X 25
PRESS BRAKE		up to 6500 long X 25 7500 long X 5
CONES		Rolled & Pressed
SQUARE TO ROUND		Presssed
TRANSITIONS		Pressed
SHEARING		up to 6000 X 12.5